Seppi – Midiforst DT

POA

The brush shredder MIDIFORST dt is the most classical forestry mulcher. Its universality makes it suitable for the most varied uses:

  • In forestry industries for right-of-way management, creation of fire breaks, vegetation management, road side maintenance…
  • In construction for land clearing and site prep…
  • In agriculture for the renewal of orchards,
  • Removal of dead plants trees in gardens

This tree shredder/mulcher comes with a two end belt drive. MIDIFORST dt mulches wood up to 30 cm [11.8”] Ø. The components of the transmission are protected under a door that may be opened for servicing. The MIDIFORST dt mulcher is well protected from dirt, dust, water and strikes.  Fixed hammer rotor in standard version with optimized combination of fiexed tools MINI DUO + MONO EXTREME and bolt-on-rotor shaft.

ADAM – Hydraulic tilting of the mulcher by gear tracking with PTO shaft alignment. With the W-shaped angles the range of motion increases and the mulcher can be moved up- and downwards even higher. This angular adjustment protects the PTO shaft and the input shaft even at high loads and supports an ideal adaptation to the conditions of the roads. Advantages: longer service life of PTO and input-shaft, even deeper digging, working with an hydraulic alignment system is easier and faster.

Available working width: 200, 225, 250 cm [79″, 89″, 98″].

  • Forestry Mulcher for Land Clearing and Vegetation Management.
  • Mulches wood up to 30 cm [11.8″] Ø
  • New MONO TIP V-LOCK aggressive rotor
  • Mulches wood up to 30 cm [11.8”] Ø
  • Standard rotor: combination of fixed tungsten carbide hammers MINI DUO + MONO EXTREME; anti-wear hammer support
  • Working speed 0-5 km/h
  • Cat. 2 central fixed ISO 3-point linkage
  • 1000 rpm gearbox with freewheel & cross shaft
  • Input shaft 1 3/4” Z=6
  • Double drive
  • 10 belts (2×5)
  • Reinforced frame
  • Hyd. rear hood
  • Skids, adjustable in height by 5 cm [2”], reinforced with hard metal plates
  • Front and rear protection: chains
  • Colour: red RAL 3020
OPTIONS
  • PTO drive shaft
  • Swinging hammer rotor
  • Fixed hammer rotor MONO TIP V-LOCK + PROTECT
  • Front attachment
  • Mechanical or hydraulic guard frame
  • Centrifugal clutch
  • ADAM™ Hydraulic tilting of the mulcher with PTO shaft alignment while keeping equal and W-shaped PTO shaft angles

Contact Information

44 Stuart St. Ardersier, Inverness-Shire IV2 7RS
PHONE:
01667 462 608

Message to FFE

[contact-form-7 404 "Not Found"]